.gif)
Top > Videos
Videos (posted on YouTube)
How to put the Positioning Stickers
How to use LOCK COVER-1 (for mounting an IC)
(1) Place the QFP on the NQPACK.
(2) Place the HQPACK.
(3) Place the LOCK COVER.
(4) Turn the LOCK COVER clockwise.
How to use LOCK COVER-2 (for connecting an emulator, etc.)
(1) Place the YQPACK on the NQPACK.
(2) Place the LOCK COVER.
(3) Turn the LOCK COVER clockwise.
(4) Insert the round YQSOCKET from the top.
(5) Now, an emulator or conversion board can be connected.
How to use JTAG Conversion Adapter SICA Connector-Free Manual Type
This product is suitable for the writing I/F of Flash/FPGA!(1) Be sure that the power is turned off on both the tool and the target board.
(2) Connect the tip of the tool's target table to the normal pitch connector of the adapter.
(3) The tip of SICA is positioned with the pad on the target board by using guide pins.
(4) Push it downward so that it is in contact with the target board.
(5) A reverse-connection may damage the device. Be sure that the connector is mounted in a correct direction.
How to use JTAG Conversion Adapter SICA Connector-Free Clip Type
This product is suitable for the writing I/F of Flash/FPGA!(1) Be sure that the power is turned off on both the tool and the target board.
(2) Connect the tip of the tool's target cable to the normal pitch connector of the adapter.
(3) Pinch the tip of SICA between fingers, and then slide to expand it.
(4) While keeping this state, align the product with the notch on the target board, and then release the product. Now, the product is in contact with the target board.
(5) A reverse-connection may damage the device. Be sure that the connector is mounted in a correct direction.